Spring Bank Sale | Ends Midnight

How To Install The Vertical Blind

Fitting The Brackets

With these instructions you will find sufficient brackets and wood screws for fitting your blind.

Top Fix Brackets

Fix brackets to ceiling or lintel with holes drilled at least 3 inches (75mm) from the wall or window frame. For blinds with 5inch (127mm) louvers or 2 1/8 inch (55mm) brackets for blinds with 3 ½ inch (89mm) louvers. End brackets should be about 1 ½ inch (40mm) from the ends of the track. Any remaining brackets should be placed evenly between these brackets.

Face Fix Brackets

Fix brackets to wall or window frame as closely as possible to the ceiling or lintel with same spacing as top fix brackets.

Fitting The Track

Track must be fitted into brackets keeping controls top side ordered.
Locate the small lip projecting from the brackets into the groove on the track. Push the track up into the brackets. Spring clip brackets will hold your track without further adjustment. If your brackets have retaining screws these should now be screwed into the other slot in the track.(DO NOT OVER TIGHTEN THE SCREWS. THIS IS UNECESSARY AND WILL DAMAGE THE TRACK.)

Fitting The Louvers

Turn hooks so that the slots are 180 degrees to the track.
Hang louvers keeping all seams one way. Your blinds is now ready to operate.

IMPORTANT: DO NOT TRAVERSE BLINDS WITH THE LOUVERS IN A CLOSED POSITION. ALWAYS TURN THEM 90 DEGREES TO THE TRACK OPERATING CORD CONTROL